Zeta Alarm Systems Infinite 8 Instrukcja Instalacji Pobierz pdf (Strona 10)

INFINITY ID2 INSTALLATION MANUAL. Software Versions: PANEL O.X-R8629 & LOOP O.J-R8624

Approved Document No: GLT-211-7-1

Issue 1.0 Author: MG Date: 22/1/2013 PAGE 9

6.2 First Fix

6.2.1 MOUNTING THE FIRE ALARM PANEL

The Infinity ID2 comes with many cable entry holes. If another entry hole is required, it is strongly recommended

that the, the termination PCBs should be removed and stored in a safe place. This would also help while fixing

the back box to the wall.

6.2.2 FIXING THE BACK BOX TO THE WALL

Figure 2: Plan view inside the enclosure without PCBs. Side view for surface installation.

Fix the enclosure to the wall using the three mounting holes provided.

Check the build & condition of the wall to decide a suitable screw fixing.

The mounting holes are designed for No 8 roundhead or countersunk woodscrews (or similar).

Remove any debris from the enclosure.

Take care not to damage the FACP during installation.

6.2.3 PLANNING CABLE ENTRY

Fig.2 above shows the location of the cable entries to facilitate planning of wiring (home runs) to be brought to

the panel.

The 230Va.c. Mains cable must be fed into the enclosure via one of the cable entries at the top right corner of

the back box. (Refer to “Connecting the Mains” on Following Page).

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 35 36

Brak uwag

Zeta Alarm Systems Infinite 8 Instrukcja Instalacji Strona 10