Zeta Alarm Systems Infinite 8 Instrukcja Instalacji Pobierz pdf (Strona 16)

INFINITY ID2 INSTALLATION MANUAL. Software Versions: PANEL O.X-R8629 & LOOP O.J-R8624

Approved Document No: GLT-211-7-1

Issue 1.0 Author: MG Date: 22/1/2013 PAGE 15

8 SOUNDERS

The Infinity ID2 has two conventional sounder circuits on board.

9. AUXILIARY OUTPUTS

9.1 Auxiliary output wiring

Auxiliary Fire Relay (AUX): This is a SELV volt free relay that operates in the alarm condition. It can be

connected to emergency lights, local fire fighting equipment such as sprinkler systems, magnetic door holders,

air conditioning shut off, etc. Extra alarm relays can be achieved by fitting extra ZIOUs to the addressable loop.

Fault Output (FAULT): This is a SELV volt free relay that operates in the Fault condition. It is Normally

Energised, which ensures it can give a fault signal, even in the event of total power loss.

Typical auxiliary output wiring

NO CM NC

FAULT RELAY

FAULT

INDICATION

DEVICE

NOTE: THE NC CONTACT

IS OPEN WHEN THERE IS

NO FAULT.

Trigger I/P

NO CM NC

FIRE RELAY

AUTO-

DIALER

Trigger I/P

The Earthing of the cable screens should be as shown on the following page.

The fault relay is used to

connect to a remote

indication device

The fire relay can be used to connect

to various devices which are activated

on a fire alarm. Eg. Auto dialler ,

magnetic door release (24V), sprinkler

system etc.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 35 36

Brak uwag

Zeta Alarm Systems Infinite 8 Instrukcja Instalacji Strona 16